If you need to add a new hard disk if you have a lot of file or data in your daily use, how do you connect the new hard disk to the host?
1. Remove the chassis baffle:
Unplug the cable on the outside of the main chassis, unscrew the largest black bolt of the chassis by hand, and then use a screwdriver to remove the screws on the back of the chassis. Stand the chassis up and pull out the baffle on both sides.
2. Mount the chassis hard disk:
Align the front of the hard disk (that is, the side where the drawing is attached) with the top of the chassis, and then insert the hard disk in the appropriate position in the figure. General chassis will reserve more than one hard drive location, not to enter the hard disk location is not inserted. After inserting the hard disk, place the screws on both sides of the hard disk.
3. Around the hard disk data line:
Put ready sata line, generally buy hard disk will not send, you can call a business to send a 3.0 line. Then start the line tightly around the screwdriver. Wind all around a line. This is because the cable is not messy and beautiful, and it is not easy to wind the CPU fan or the host fan.
4. Connect the hard disk data cable power cable:
Plug the data cable around the top into the motherboard above the sata3.0 interface, if it is 2.0 then access the 2.0 interface, the sata line is backwards compatible, so 3.0 can be inserted into the 2.0 port, but the transmission performance drops. As shown in the figure, you can insert any one of the blue 3.0 ports, and the other end is inserted into the hard disk data port, which is the only one that cannot be inserted in the wrong slot. The 3.0 line also showed an elbow and a straight line. This one can be inserted into the hard disk. In fact, it is convenient for winding. This can be based on actual needs, that is not wrapped around the chassis, put that head into the hard disk can be.
5. Connect the power cable.
Then unplug the sata power cord in the picture. In the picture, the red circle is the dedicated power cable for the hard disk. There are two types: the flat port, the round port, the flat port, and the one inserted into the hard disk. No need to insert. If the power supply only has a round mouth, then the round port power port of the hard disk can be inserted, and it is not this port that is irrelevant. Then insert it, buckle the chassis cover, and connect the external wiring. Note that this time the hard disk is not a system, if you remove the original hard disk will cause the situation can not boot. You need to install the system before you can use it.
Since its foundation in 2010, STC-CABLE have been specializing in products and solution for Mobile & PC accessories, such as data cable, Audio &Video cables and Converter (USB,HDMI, SATA,DP,VGA,DVI RJ45 etc) to meet various needs of customers. We will understand that quality is premise of everything for an international brand. All STC-CABLE products use RoHS complaint raw material, reducing the environmental impact.
Send your message to us:
Post time: Jun-27-2018