Warranty                                                                       2-years

Cable Shield Type                                                         Flat Slim Thin Ribbon FPC Cable

Connector Plating                                                         Nick

Color                                                                              Black

Connector Style                                                             Straight to 90-degree Angle

Product Weight                                                              0.8 oz [25 g]

Wire Gauge                                                                   28/28 AWG

Weight                                                                           0.8oz [25g]

FPV Flat Slim Thin Ribbon FPC Micro USB 90-degree cable

FPV Flat Slim Thin Ribbon FPC Micro USB 90-degree cable

The FPV Flat Slim Thin Ribbon FPC Micro USB 90-degree cable Can directly transmit AV signal for sync and charging. Very soft, lightweight, flexible, thin slim USB cable. low profile. less than 5g

Important before purchase:
MICRO USB1 and MICRO USB2 are both 90 degrees.
However, they have a reverse/mirror direction/orientation,
Please check before placing your order.
In this link, the micro USB is micro USB 1

Warm reminder:
Please check the orientation of micro ends before purchasing.
(1) Various USB ends are available:
Micro USB 90 degree 2 types, USB type C and standard USB A
Those USB ends can be combined as per your application.
(2)Length available :5CM;15CM;30CM;40CM;50CM;60CM;80CM;100CM
Please contact us for that if you can’t find it on the listing.

Answer & Question

Question: Hi is it possible to remove the USB plug and solder wires to the +5v and and terminals by hand?

Answer: Yes, the USB plug can be removed. you can unlock the latch /little black holder. It can be soldered.  please be very swift and control the temperature around 200 degrees (lower temperature ) while soldering

Question: Please can you confirm the length? I ordered one and it was only 50mm (5cm) long, not 50cm as per the title.

Answer: Hello It should be 50cm. please contact the seller and send them the photo for exchange (there is contact on the warranty card)

Question: What are the dimensions of the micro USB end? (i.e. how much it will protrude from a micro USB port & how long from 90 bend to the ribbon cable? thanks!

Answer: In my case; where the micro USB connector on the device is not recessed, the connector of the cable protrudes 8,5mm from the device. When the connector is inserted into the device 2mm of the male part of the connector is still visible. From the center of the micro USB connector to the beginning of the ribbon cable is 10mm. The micro USB end is 12,1mm at the widest. I hope this information makes sense and is useful to you.

Feedback

1>"This was just what I needed, and it worked perfectly.
The only drawback the cable pulled out of the end of the USB connection. Not really the fault of the cable, I had the device hooked up to it while plugged in and dropped it. The weight of the device ripped the cable out of the connector.
Wish it had been a bit stronger, but I ordered a new one and I will reinforce it with epoxy and shrink tubing. Should be fine then."

2>"I got the 20CM, and it's almost, but not quite long enough for 100% panning in both directions. It'll make it about 80% in one direction. I'd get the 30CM if I get another.
It appears fragile, but lightweight and minimal is a feature of a gimbal cable. It comes with some heat shrink tubing to strengthen the ends."

3>"If you are building an internal USB attachment this is by far the best to use."